Official firmware downloads and release notes for the X1 Carbon and X1. Normally installed over the air from the printer or Bambu Studio; the download is for offline microSD updates.
Updating from the printer screen or Bambu Studio is the recommended route. Only use the microSD file if your printer is offline.
Official open-source firmware for Prusa's 32-bit Buddy-board printers. Each GitHub release lists the .bbf file for every supported model plus a full changelog.
Pick the .bbf for your exact model (e.g. MK4 and MK4S files are different). Pre-release builds are marked alpha, beta or RC.
Community menu-driven installer for rooted K1-series and Ender-3 V3 KE/Plus printers: Moonraker, Fluidd/Mainsail, Klipper macros, camera and other add-ons.
Requires root access on the printer. Back up your configuration first; a stock firmware update can wipe what the script installed.
Community step-by-step guide for replacing the SV08's stock software with mainline Klipper (via KIAUH on the BTT CB1 image).
Back up your config and stock firmware before you start; writing the eMMC erases it. The guide pins a specific CB1 image version, so follow it exactly. Swapping the mcu and extra_mcu serials can turn the heater on full.
Community replacement image for the Elegoo Neptune 4 series that swaps the stock software for mainline Klipper, Moonraker, Fluidd/Mainsail and KAMP, with a built-in updater.
Replaces the stock system image. Read the project wiki before installing, including how to return to stock.
For Elegoo Neptune 4, Elegoo Neptune 4 Max, Elegoo Neptune 4 Plus, Elegoo Neptune 4 Pro
Flashing firmware can brick a printer if the wrong file is used. Always match the file to your exact printer model and board revision, and check the checksum before flashing.