As an Amazon Associate this site earns from qualifying purchases.

TPU Printing Guide

Published

How to print TPU

Search

TPU absorbs moisture from the air faster than most filaments. When wet filament gets to the hotend, the trapped water turns to steam. That causes bubbling, popping sounds, stringing, rough surfaces, extruder gear slippage, adhesion issues and weak parts.

Best practice is to place it in a filament dryer overnight before printing.

Tubes and bends between the spool and the extruder create friction, and soft TPU drags against them more than stiff filament like PLA does. This can cause wear and underextrusion.

Best practice is to print a top-mount spool holder and feed TPU straight from the spool into the extruder without a tube.

Most non-adjustable extruders are set up for hard filaments like PLA. Soft TPU gets squashed if the extruder grips it too tightly, which can lead to uneven feeding and jams.

Best practice is to use an extruder with adjustable tension and back the tension off until the gears grip the filament without flattening it.

TPU bonds very strongly to smooth PEI, and parts can fuse to the plate or damage it when you try to remove them.

Best practice is to print on a textured plate, or apply glue stick to smooth PEI as a release agent.

Quality, reliability and speed are determined by your print settings. Many manufacturers recommend very slow speeds. While this is a safe starting point, it is best to perform the slicer calibrations to create a tuned profile, and on a CoreXY printer such as the Creality K2 Series, you may be able to print a lot faster.

Calibration

Discussion